Raspberry pi install monit1/3/2024 So the first thing we do is enable SSH so we can connect remotely to the PI. We don’t want to connect a keyboard and monitor to our Raspberry Pi everything we need to update or change something. Otherwise, you can skip this step and continue with Step 2. This step is only required when you haven’t enabled SSH in the Raspberry Pi Imager tool. You will get a warning that all data will be removed, click Ok and get a coffee □.Set username and password for SSH connection.Click on Settings (Gear icon) in the lower-right corner.Select your MicroSD card (check the size and drive letter!).Place the MicroSD card in your computer and open Raspberry Pi Imager: We are going to install the 64-bit lite version of Raspberry Pi OS, this version comes without a desktop which we don’t need. The advantage of this tool is that we can select the Raspbian version we want to install, enable SSH and configure the wireless network. We will use the Raspberry Pi Imager to easily install the correct Raspbian OS version. Step 1 – Getting the Raspberry Pi up and runningįirst, we are going to start by installing Raspbian on de MicroSD card. Putty – Optional (to connect to the Pi with SSH).Advanced IP Scanner – Optional (to find the IP address of the PI).These are the fastest at the moment with 10MB/sec.ĭownload the following software to get started: You can use a Model 3B, but if you have to buy one new I recommend getting a Model 4BĪlso, you are going to need a MicroSD card, buy atleast a class A 2 card. Of course, we need to buy a Raspberry Pi. What do we need for the Unifi Controller and Raspberry Pi?īefore we can start with installing the Unifi Controller on the Raspberry Pi we need to get some parts and download some software. The installed version of UniFi controller is 7.4.156 during the test. This article fixed the problem with MongoDB and is based on Raspbian OS Lite 64-bit. Note I have updated and tested this article on Jun 29th, 2023. In this article, I will help you install the Unifi Controller on the Raspberry Pi step-by-step in 5 minutes. To do this I need to Unifi Controller to be running 24/7, so I needed a device to run the Unifi Controller on, something small, cheap, and with low running costs. I have some smart products at home and one of the things I wanted to do is read out the connected WiFi devices.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |